Current location：
hot product
hot news
message
detail
Anaerobic flat sealant
Anaerobic single-component adhesive. When exposed to the air, it remains in a fluid state. When assembling parts, the adhesive liquid flows into the gap between the pits and scratches to achieve the contact between metals, isolate the air and can be quickly cured under the action of metal ions to form an elastic or rigid adhesive layer and play a sealing role. Improve seal reliability, increase overall rigidity and load capacity. It can be formed and cured on site. The extruded part does not cure due to exposure to air, which can be convenient. The formed gasket is pressure-resistant, temperature-resistant and non-corrosive. Easy to use, with excellent sealing applicability. Instead of gasket, small gap plane static seal, widely used in automobiles, motorcycles and various machinery, equipment box, flange, end cover and other joint surface seal.
1510 Flat sealant
Packing specification: 310ml/ PCS, 30 PCS/box
High temperature resistance up to 204℃, good rigidity of adhesive layer, thixotropic viscosity, solvent resistance, no corrosion, good resistance to media, used for rigid structure, tight fit, flat static seal or gasket coating. Such as engine gear box separate surface, crankcase separate surface, cover plate and other plane seal.
1515 Flat sealant
Packing specification: 310ml/ PCS, 30 PCS/box
Universal, flexible adhesive layer, thixotropic viscosity, solvent resistance, non-corrosive, for sealing surface with telescopic or vibrating joint surface static seal. Such as sealing pump, gearbox, body end cover, flange, axle and other parts of the joint surface.
1518 Flat sealant
Packing specification: 310ml/ PCS, 30 PCS/box
Universal, flexible adhesive layer, excellent fluid resistance, no corrosion, good solvent resistance. Especially suitable for aluminum and aluminum alloy surfaces. Such as car, motorcycle engine seal.
Main physical and mechanical properties
Product type number |
External view |
Fill gap (mm) |
Seal oil pressure (MPa) |
Operating temperature (° C) |
25℃ Initial solid/full solid (hr) |
1510 |
Red paste |
0.25 |
36 |
-54 to +204 |
1 to February 24 |
1515 |
Purple paste |
0.25 |
34 |
-54 ~ +150 |
1 to February 24 |
1518 |
Red paste |
0.25 |
36 |
-54 ~ +150 |
1 to February 24 |
Key points of use
l Sealing surface with acetone to remove oil and other impurities, dry.
l Apply the sealant to the sealing surface in a continuous circle.
l Align and close, properly tighten the bolts to avoid dislocation, and then assemble after 20 minutes.
l Stationary 30 ~ 60 minutes after positioning, 24 hours curing.
