It is used for cylindrical parts assembly,fill the internal space between the parts and solidified into flexible rubber and improve the strength of the matching parts. It is used in the shaft sleeve, bearing and pin column ,pulley assembly hold of cylindrical parts.

Single component,no solvent,room temperature curing,many choices. It can fully satisfy fill gap and sealant,the excessive coordinates and interference fit,to receive strength evenly .It can eliminate such as keys and keyways,shaft and shaft sleeve of the play,avoid the microtremor wear,occlusion,distortion,etc.,simplify and reduce the assembly process and improve production efficiency .

It can relax fit tolerance and choose the surface of the lower precision. It helps find calibration point bearing and shaft sleeve,rigid assembly production of more sophisticated,prevent the metal between micro vibration and corrosion of metal fittings.

FS-1603 Retaing Compound Adhesive 

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

Genaral purpose,high intensity ,low viscosity, anti-oil . It applies slightly oily surfaces and inert surface,and it is especially suitable for dirty surface and inert metal surface 0.1mm gap solid,such as brushing,bearing,small motor shaft and bushing assembly.

FS-1609 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

Gernal purpose,high intensity,low viscosity,sealing built/shaft ,bearings,small motor shaft and bushing,repair wear or out-of-tolerance holes/shafts parts,fix gap 0.1mm

FS-1620 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

Resistance to high temperature(204℃).High strength ,high viscosity,not flowing . It is used for intermittent work condition of the high temperature of 150℃～204℃ retaining valve casing,injection molding machine set,valve set,cylinder liner keyway,etc.

FS-1638 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

Ultra high strength,high viscosity .It can fit larger gap of shaft and hole,key. It is used for periodic load or dynamic load cases and high strength condition.

FS-1648 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

High strength ,low viscosity ,fast curing.Filling gap is 0.15mm.It is applicable to small fitting gap. The continous working temperature is higher thus it need to be quickly fixed.

FS-1660 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

High strength ,high viscosity ,paste. It is used to fill the gap(below 0.5mm),shaft,sets,key,such as bearing cylindrical mating parts. It is used to repair shaft of severe wear,hole,slotting,bearings,bushings,etc.

FS-1680 Retaing Compound Adhesive

Packaging Spec.: 50ml/tube,120 bottles/carton;250ml/bottle,40bottles/carton 

High strength ,medium viscosity,suitable for clearance or interference fit,can replace the press fit,holding casing,shaft,gear,belt rotor,repair hole/shaft and ultra poor gap〈0.25mm parts,fixture.

                                                                          Technical Data Sheet 

Operation Key 

l    The effect is best when used in cleaning and non-oil surface
l    Hold 24 hours for full curing then put into use.