Current location Current location:home > Product > Vehicle Assembly & Sealing
Product
Product

Product

product

Automobile Lamp Silicone Sealant

Description927 automobile lamp silicone sealant is specially used for automobile lamps and lanters,sp……

Related
message
detail
content details

Description

   927 automobile lamp silicone sealant is specially used for automobile lamps and lanters,special lighting and electronic component area . One component ,low modulus ,neutral cure silicone sealant , It is suitable for sealing and electrical insulation .


    Features

. One component neutral curing ,weak volatility ,superior electric insulation performance . It is very good to stick to most materials

.Excellent climate ageing resistance , and also has resistance to ultraviolet ray ,ozone resistance ;water resistance , superior anti moisture and waterproof

.Superior high and low temperature resistance performance , the performance remains stable within the sope of minus 50-180 degrees and it can be used for a long time ;

 

Technical Data Sheet 

Colorwhite or  black ViscosityPaste
Density1.35~1.4g/cm³Hardness(Shaw A)≥30
Tensile Strength≥1.5MPaTensile Shear Strength≥1.0MPa
Elongation at break ≥250%Working Temperature-50~180℃
Atomization testNo atomazationSurface curing 12mins(25℃,50%RH)


Use Method 

Be sure of substrate 

Firstly exclude unsure factor , eg.: some metal coating and painting .

Clean loose layer of part need to apply glue , if it has coating or painting , engough adhesion force is needed

Use special cleaning agent clean the part need to apply glue , make it clean ,hard ,dry without grease and dirt such as release agent ,curing film ,water repallent agent .

Apply glue

Cut appropriate glue mouth according to joint surface and gap size , extrude glue evenly , extruding glue at size of o-ring will be better. After apply glue to joint surface , immediately assemble and tighten , the time from extruding glue to assemble should control within 3 minutes , more shorter ,more better , assembled parts should be vulcanized at 23±2℃,after 5 hours then move to next procedure  . Pressure test should be handled after 24h of vulcanization test .

After vulcanization , extra fluid glue left on joint surface is cleaned with sharp kinfe , and must not use finger to tear it , or use cotten yarn with oil to clean it .

 Take it apart

When take it aprt , use woodstick beat along the side of joint surface, after loose ,glue on joint surface can be cleaned with copper wiper .or use cotton yarn with oil to clean it .

 

Store and shelf life

Belong to non hazardous goods ,store in dry and cool place under 27, shelf life is 9 months , using it within 6 months after buy it is suggested .

 

Notice

It is non-toxic after curing , but it should avoid contacting with eyes and children before curing . The working area should keep ventilate .

Packaging :240kg/barrel 

MESSAGE

LEAVE A MESSAGE