Current location：
hot product
hot news
message
detail
Casting glue
Performance characteristics
1, the cured material has a high strength, can be carried out all kinds of mechanical processing.
2, a wide range of applications, suitable for repair of various metal materials.
Product characteristics
It is a high performance polymer metal repair material obtained by the composite of alloy powder and toughened heat resistant resin. It has high strength and can be processed.
Technical index
Table of physical and mechanical properties of casting glue |
|||||||
colour |
Physical state |
Density (g/cm3) |
Compressive strength (kg/cm2) GB/1041-2008 |
Shear strength (kg/cm2) GB/7124-2008 |
Tensile strength (kg/cm2) GB6329-2009 |
Bending strength (kg/cm2) GB1042-1999 |
Hardness (Shore D) ASTM-D-2556 |
Silver grey |
paste |
1.43 |
832 |
223 |
157 |
466 |
81 |
Casting glue curing characteristics table (test conditions: temperature 20 ~ 25℃, relative humidity 55) |
||||
Operational time limit (min) |
Curing time |
Need curing time before full load operation |
Operating temperature (℃) |
Withstand temperature (℃) |
30 ~ 60 |
Room temperature 24h or room temperature 2h+80℃1h |
48h |
-60 to 120 |
140 |
Special instructions
1. Surface treatment: The surface is roughened and cleaned with cleaning agent.
2. Preparation: According to the mass ratio A:B=1:1 or volume ratio A:B=1:1, the two components of A and B are mixed evenly, and used up within the specified operating time limit.
3. Coating: The mixed material is coated layer by layer on the part to be repaired, and a layer should be compacted so that it is fully infiltrated with the substrate. If mechanical processing is required in the following sequence, an appropriate amount of processing allowance should be set aside.
4. Curing: 20 ~ 25℃ curing for 12 hours can be machined, put into use after 24 hours, if the temperature is low should be heated or extended curing time to cure.
Matters needing attention
1. This parameter is obtained under laboratory conditions. Due to the complexity of the actual working conditions, it is recommended that users do pre-test according to the actual working conditions.
2. When the ambient temperature is lower than 15 ° C, the curing time will be extended, and appropriate heating measures should be taken.
3. When the ambient temperature is higher than 25℃ or the mixing amount is too large, the curing speed will be fast, and the operation time after mixing should be appropriately shortened.
Storage life
It is non-dangerous goods, stored in a cool and dry place with a shelf life of 24 months. Packing: 100g/ set.
