产品中心新网站资料
产品中心新网站资料

产品中心新网站资料

FS226 wear resistant coating

FS226 wear-resistant coating performance characteristics 1. With metal, wood, stone and other substra……

Related
message
detail
content details

FS226 wear resistant coating

Performance characteristics

1. High bonding strength with metal, wood, stone and other substrates;

2. No flow, short molding time, fast curing speed;

3. Suitable for large area repair of fine particle wear equipment and preparation of pre-protective coating.

Product characteristics

The wear-resistant composite coating with hard spherical small particle ceramics and quartz as the aggregate has high bonding strength with a variety of substrates. For large area repair and pre-protection coating of fine particle wear equipment, such as feeders, scrapers, hoppers and chutes.

Technical index

Mixed color

Mixed state

Tensile strength (Mpa) GB/T 6339-2009

Compressive strength (MPa) GB/T 1041-2008

Shear strength (MPa) GB/T 1041-2008

Bending strength (MPa) GB/T 1041-2008

Hardness (Shors D) GB/T 241-2008

gray

paste

35.6

88.0

18.5

32.5

95

FS226 Curing properties (test condition: room temperature)

Operating time

Curing time

Full load curing time

Operating temperature

density

30min

24h at room temperature

48h

-60 ° C to 160 ° C

2.09

 

Usage method

1. Surface treatment: roughening the parts that need to be treated; Clean the roughened surface to achieve no

Oil pollution, no dust;

                                                                           

2. Configuration: Mix A and B components evenly according to the weight ratio 4:1, and use them up within 30 minutes; The curing speed is affected by temperature, and the general amount of glue should not be greater than 1.5 kg;

3. Coating: The thickness of this coating is appropriate in 2 ~ 8mm, the mixed material is divided into two layers coating, one layer and the substrate fully infiltrate and compacted, then apply two layers and smooth until;

4. Curing: It can be put into use for 24 hours under the condition of temperature 25℃. Under the condition of general low temperature, proper heating or extension of curing time can be used to cure.


Storage and shelf life

Non-dangerous goods, sealed storage in a cool and dry place, shelf life of 12 months;

Packing: 10kg/ group, 20kg/ group, plastic drum.  

MESSAGE

LEAVE A MESSAGE