FS587 reducer adhesive  is used to stick and bonding with body of decelerator , its unique perforamcen can make sure reducer keep in better working condition for long time 。

Features

◆One componcent neutral curing , no corrosion , it has good sticking to alluminum ,copper ,stainless steel and various metal and non metal materisl such as PC ABS and engineering plastic 

◆. Water and oil proof , shock resistance , viberation reistance , it will not broken and leaked after use 

◆.Superior resistivity , good heat resistance ,scope of temmperature should be controlled at -60℃～200℃

Technical Data Sheet 

Use Method 

◆Be sure of substrate

 Clean loose layer of part need to apply glue ,if it has coating or painting layer , engough adhesion force is needed . If adhesion force is small , use relavent tooling such as steel wire ball to clean part ,make it clean ,hard ,dry without grease and dirt such as release agent ,curing film ,water repallent agent 

◆Apply glue

Cut glue mouth according to size of joint surface and gap , extrude glue evenly , extruding glue at size of o-ring will be better .After apply glue to joint surface , immediately assemble and tighten , the time from extruding glue to assemble should control within 3 minutes , more shorter ,more better .After vulcanization , extra fluid glue left on joint surface is cleaned with sharp kinfe , and must not use finger to tear it , or use cotten yarn with oil to clean it .

Store and shelf life

Belong to non hazardous goods ,store in dry and cool place under 27, shelf life is 1 year. 

Notice

It is non-toxic after curing , but it should avoid contacting with eyes and children before curing . The working area should keep ventilate .

 Packaging :310ml/tube,30tubes/carton